Flow angularity investigations in an automotive slotted wall wind tunnel
Journal article, 2019

The Volvo Cars aerodynamic wind tunnel has had a vortical flow angularity pattern in the test section since its original commissioning in 1986. The vortical flow nature persisted after an upgrade in 2006, when the fan was replaced and a moving ground system was introduced. It has been hypothesized that the cause for this flow angularity pattern was leakages around the heat exchanger installed in the settling chamber. The present paper tests this hypothesis by measuring the flow angularity in the test section before and after sealing the leakages. The findings show that the leakage path around the heat exchanger does not influence the flow angularity, and that the current pattern is different compared to the commissioning after the upgrade. This prompted an investigation of the influence from the turbulence screens, which were changed after the upgrade commissioning. These investigations indicate that the probable cause of the vortical flow angularity pattern is residual swirl from the fan. Force measurements on a reference car with and without extra induced flow angularity show that the flow angles measured in the tunnel for regular operation are most likely small enough to not have a significant effect on the measured aerodynamic forces.

flow uniformity

wind tunnel

slotted wall

flow angularity

Author

Emil Ljungskog

Chalmers, Mechanics and Maritime Sciences, Vehicle Engineering and Autonomous Systems

Simone Sebben

Chalmers, Mechanics and Maritime Sciences, Vehicle Engineering and Autonomous Systems

Alexander Broniewicz

Volvo Cars

Energies

1996-1073 (ISSN)

Vol. 12 23 4575

Areas of Advance

Transport

Subject Categories

Vehicle Engineering

Fluid Mechanics and Acoustics

DOI

10.3390/en12234575

More information

Created

1/2/2020 1