Attempt of the Metallic 3D Printing Technology for Millimeter-Wave Antenna Implementations
Paper i proceeding, 2016

3D metallic printing technology is attempted to implement millimeter-wave (mmWave) antennas. Based on laser beam melting (LBM) technology, the cost and turnaround time of metallic horn antenna fabrication is effectively reduced compared with traditional milling and injection moulding. A conical and a pyramidal horn antenna are printed in 316L stainless steel, both of which demonstrate satisfactory performance compared with simulation, as well as comparable performance with commercial horn antennas. Surface roughness of the printed horn antennas are measured and analyzed, showing improvement upon former designs. The 3D printing technology proves its great potential for further exploration.

pyramidal horn antenna

3D printing

surface roughness

conical horn antenna

V-band

Författare

Bing Zhang

Chalmers, Mikroteknologi och nanovetenskap, Mikrovågselektronik

Peter Linner

Chalmers, Mikroteknologi och nanovetenskap, Mikrovågselektronik

Camilla Kärnfelt

Institut Mines-Telecom

Eric Tam

Chalmers, Mikroteknologi och nanovetenskap

Ulf Södervall

Chalmers, Mikroteknologi och nanovetenskap, Nanotekniklaboratoriet

Herbert Zirath

Chalmers, Mikroteknologi och nanovetenskap, Mikrovågselektronik

Asia-Pacific Microwave Conference, APMC 2015

Vol. 2

Ämneskategorier

Telekommunikation

DOI

10.1109/APMC.2015.7413011

Mer information

Senast uppdaterat

2020-03-02