Heat extraction from a utility-scale oxy-fuel-fired CFB boiler
Artikel i vetenskaplig tidskrift, 2015

The temperature and heal extraction parameters of a utility-scale, oxy-fuel-fired boiler are investigated using a mathematical model that was originally developed and validated with data from 100-kW(th) to 4-MWth, oxy-fuel-fired circulating fluidized bed units. This work involves an existing furnace, which was developed for air bring, and evaluates its operational potentials under oxy-fuel conditions, allowing additional heat extraction through an external heat exchanger (EHE). The modeling shows that even though the heat extraction levels from the entire furnace, flue gas pass, and EHE increase with increases in the inlet 02 concentration, the heat extraction from the EHE dominates the heat extraction for high inlet 02 concentrations and, consequently, requires an increase in the circulating solids flow, which transfers heat from the furnace to the seal. While maintaining the same dense bed temperature as in the air Fired case, an increased inlet 02 concentration in the oxy-fired case leads to dramatic increases in the maximum in furnace temperature and maximum heat extraction flux rate. Thus, to control the maximum furnace temperature, the circulating solids flux must be increased beyond what is required to close the heat balance across the CFB loop. For the conditions investigated, limitation of the maximum furnace temperature to 1273 K yields that 48%, 56%, and 70% are the highest possible inlet oxygen concentrations if the external circulation flux rate is limited to 10, 20, and 30 kg/m(2)/s, respectively.

Gas solids flow

Design

Heat transfer

Scale up

External heat exchanger (EHE)

Oxy-fuel combustion

Författare

Sadegh Seddighi

Chalmers, Energi och miljö, Energiteknik

David Pallarès

Chalmers, Energi och miljö, Energiteknik

Fredrik Normann

Chalmers, Energi och miljö, Energiteknik

Filip Johnsson

Chalmers, Energi och miljö, Energiteknik

Chemical Engineering Science

0009-2509 (ISSN)

Vol. 130 144-150

Ämneskategorier

Kemiska processer

DOI

10.1016/j.ces.2015.03.015

Mer information

Skapat

2017-10-07