Characteristics of a hot wire microsensor for time-dependent wall shear stress measurements
Artikel i vetenskaplig tidskrift, 2003

Hot-wire microsensors for the purpose of measuring the instantaneous velocity gradient close to a wall have been designed and their characteristics are evaluated. The sensors were made using MEMS (microelectromechanical systems) technology, which permits the fabrication of various micro geometrical configurations with high precision and good repeatability. The design is based on estimates of the heat rates from the sensor wire to the air, through the supports, and to the wall. Several hot-wire configurations were fabricated with wires positioned in the range of 50-250 μm from the wall. Requirements for the design and details of the fabrication methodology are outlined. The hot-wire microsensors were calibrated and tested in a flat-plate boundary layer with and without pressure gradient and were found to have good steady-state characteristics. In addition, the developed sensors were used for preliminary studies of transitional phenomena and turbulence, and the sensors were found to have good time-dependent response as well.

Författare

Lennart Löfdahl

Chalmers, Tillämpad mekanik

Valery Chernoray

Chalmers, Tillämpad mekanik

S. Haasl

Göran Stemme

M. Sen

Experiments in Fluids

Vol. 35 3 240-251

Ämneskategorier

Strömningsmekanik och akustik

Reglerteknik

Annan elektroteknik och elektronik

Mer information

Skapat

2017-10-08