Towards an optimized flow-sheet for a SANEX demonstration process using centrifugal contactors
Journal article, 2009

The design of an efficient process flow-sheet requires accurate extraction data for experimental set-up used. Often this data is provided as equilibrium data. Due to the small hold-up volume compared to the flow rate in centrifugal contactors the time for extraction is often too short to reach equilibrium D-ratios. In this work single stage kinetics experiments have been carried out to investigate the D-ratio dependence of the flow rate and to compare this with equilibrium batch experiments for a SANEX system based on CyMe4-BTBP. The first centrifuge experiment was run with spiked solutions while in the second a genuine actinide/lanthanide fraction from a TODGA process was used. Three different flow rates were tested with each set-up. the results show that even with low flow rates, only around 9% of the equilibrium D-ratio (Am) was reached for the extraction in the spiked test and around 16% in the hot test (the difference is due to the size of the centrifuges). In the hot test the lanthanide scrubbing was inefficient whereas in the stripping both the actinides and the lanthanides showed good results. Based on these results improvements of the suggested flow-sheet is discussed.

diamex process

minor actinides

Centrifugal contactor

Kinetics

CyMe4-BTBP

Minor

Extraction

current extraction process

actinides

Partitioning

recovery

Author

Daniel Magnusson

Chalmers, Chemical and Biological Engineering, Nuclear Chemistry

B. Christiansen

European Commission (EC)

J. P. Glatz

European Commission (EC)

R. Malmbeck

European Commission (EC)

G. Modolo

Jülich Research Centre

D. Serrano-Purroy

European Commission (EC)

C. Sorel

The French Alternative Energies and Atomic Energy Commission (CEA)

Radiochimica Acta

0033-8230 (ISSN)

Vol. 97 3 155-159

DOI

10.1524/ract.2009.1587

More information

Latest update

3/10/2025