Optimization of laser-induced graphene membrane for simultaneous photo- and electro-thermal membrane distillation

Journal article, 2024

To optimize the Laser-Induced Graphene (LIG) Janus membrane, this study investigated the effects of membrane pore structure, polydimethylsiloxane (PDMS) coating sequence and addition of silver (Ag) nanoparticles on membrane distillation (MD) performance. This study aimed to enhance the photothermal characteristics of graphene while using the intrinsic electrical conductivity for simultaneous photo- and electrothermal MD. Operating at the same photo- and electro-thermal power input, the LIG Janus membrane made by treating the membrane face with smaller pores (i.e., shiny side) gave an improved flux performance of up to 53.6% and a decrease in specific energy of 35.4% compared to that by treating the membrane face with larger pores (i.e., dull side). The effect of the PDMS coating sequence also depended on the pore structure. For the face with smaller pore structures, coating PDMS before laser irradiation (PDMS-BLSS) gave a flux improvement of up to 24.5% and a decrease in specific energy of 19.7%, compared to coating PDMS after laser irradiation (PDMS-ALSS). As for the face with larger pore structures, coating PDMS before laser irradiation (PDMS-BLDS) resulted in a flux reduction of up to 20.8% and an increase in specific energy of 27.1%, compared to coating PDMS after irradiation (PDMS-ALDS). The LIG Janus membranes embedded with Ag nanoparticles led to improved photothermal heating properties, improving flux by 43.1–65.8% and decreasing specific energy by 15.2–30.5% while maintaining similar electrothermal heating properties. Carrying out simultaneous photo- and electro-thermal MD indicates that only the Ag-doped Janus LIG membrane gave a synergistic effect whereby the flux of the combined heating mode was higher than the summation of the fluxes obtained when operating in the individual heating modes.