Kinetic modeling of sulfur poisoning and regeneration of lean NOx traps
Journal article, 2010

Sulfur poisoning and regeneration of lean NOx traps were investigated using experiments and kinetic modeling. A commercial Pt, Rh and barium containing NOx storage catalyst was used. The catalyst also contained oxygen storage material. First the oxygen storage capacity (OSC) was investigated using steps with oxygen and hydrogen. The OSC was substantial with a total use of all hydrogen (1%) for about 20 s. The results were similar at the three investigated temperatures (300, 400 and 500 degrees C), indicating that it is a low activation barrier connected with the process. Further, no effect was observed when adding 15 ppm SO2 to the feed. Since no SO2 was observed in the outlet it is possible that SO2 is adsorbed during the lean period and then reduced to form H2S in the rich period (not measured). Further, the NOx storage was found to decrease during SO2 exposure, and the decrease was linear and dose dependent. In addition, we investigated different regeneration strategies. When using 500 ppm H-2 for 60 min at 700 degrees C the regeneration was poor. However, when adding 5% CO2 to the 500 ppm H-2 the regeneration was increased drastically. Further, the regeneration was decreased when decreasing the temperature to 600 degrees C, and further decreased when using 500 degrees C. In addition, it was beneficial with increasing the hydrogen concentration. The kinetic model contains three sub-models; (i)NOx storage and regeneration, (ii) oxygen storage and reduction and (iii) sulfur poisoning and sulfur regeneration. It was crucial to add NOx storage on two sites; barium and alumina. The NOx adsorbed on alumina is more loosely bound. Further, in the model formation of sulfates were added on both components. This was important in order to describe the rate of the sulfur deactivation. If sulfur was adsorbed only on barium the deactivation would have been too rapid. The model could describe the experimental features well.

Sulfur poisoning and regeneration

Lean NOx traps

SO2

pt-ba/gamma-al2o3 catalyst

adsorption

Kinetic modeling

conditions

NOx storage

Catalyst deactivation

exposure

reducing agent

pt/bao/al2o3

no(x) storage

so2

in-situ ftir

reduction

storage catalysts

Author

Louise Olsson

Competence Centre for Catalysis (KCK)

Chalmers, Chemical and Biological Engineering, Chemical Reaction Engineering

Marielle Fredriksson

Competence Centre for Catalysis (KCK)

Richard Blint

General Motors

Applied Catalysis B: Environmental

0926-3373 (ISSN) 1873-3883 (eISSN)

Vol. 100 1-2 31-41

Areas of Advance

Transport

Materials Science

Subject Categories

Chemical Engineering

DOI

10.1016/j.apcatb.2010.07.004

More information

Latest update

7/22/2019