Experimental and simulation analysis of texture formation and deformation mechanism of rolled AZ31B magnesium alloy under dynamic loading
Journal article, 2014

Magnesium alloys components are potentially used under shock loading conditions. Considering the fact that deformation behavior is completely different under high strain rate conditions compared to quasi-static conditions, it is very important to evaluate the dynamic mechanical response and deformation mechanisms of magnesium alloys under impact loading. In this research, texture formation, microstructural changes and dynamic deformation behavior of rolled AZ31B in the tempered H24 stress-relieved conditions, shock-loaded under compressive dynamic loading, were investigated. Texture measurements showed that the as-received AZ31B alloy had a strong (00.2) basal texture. Four groups of cylindrical samples were cut in the rolling direction (RD), in 45 degrees to the RD, in the transverse direction (TD) and in the direction perpendicular to the RD-TD plane. Dynamic shock loading of the test samples were conducted using Split Hopkinson Pressure Bar at room temperature at strain rates ranging from 600 to 1100 s(-1), while loading direction was parallel to the longitudinal axis of the cylindrical samples. After high strain rate deformation, although the loading direction was different, a strong (00.2) basal texture was observed in all samples. It was inferred that increasing the strain rate led to an increase in strength and ductility, but to a decrease in twinning fraction, indicating the possible activation of non-basal < c+a > slip systems. Besides, a high degree of mechanical anisotropy was found for all strain rates used such that the lowest strength was registered for the samples cut along the direction parallel to the rolling direction. A viscoplastic self-consistent model with a tangent approach was used to corroborate the experimental textures and possible deformation mechanisms by simulation.

Mechanical anisotropy

Rolled magnesium alloy

Deformation texture

Twinning

Author

H. Asgari

University of Saskatchewan

J. A. Szpunar

University of Saskatchewan

A. G. Odeshi

University of Saskatchewan

Lunjie Zeng

Chalmers, Applied Physics, Eva Olsson Group

Eva Olsson

Chalmers, Applied Physics, Eva Olsson Group

Materials Science & Engineering A: Structural Materials: Properties, Microstructure and Processing

0921-5093 (ISSN)

Vol. 618 310-322

Subject Categories

Materials Engineering

DOI

10.1016/j.msea.2014.09.043

More information

Latest update

3/29/2018