Simplified FEA models in the analysis of the redistribution of beneficial compressive stresses in welds during cyclic loading
Paper in proceeding, 2018

The fatigue life of welded joints can be improved by modifying the weld toe geometry or by inducing beneficial compressive residual stresses in the weld. However, in the second case, the induced compressive residual stresses may relax when the welded joint is subjected to cyclic loading containing high tensile or compressive stress peaks. The stability of induced compressive stresses is investigated for a longitudinal gusset made of a S355 steel. Two methods are considered; either carrying out a high frequency mechanical impact (HFMI) treatment after welding or alternatively using low transformation temperature (LTT) electrodes during welding. The specimen is then subjected to a cyclic loading case with one cycle with a tensile peak (with magnitude reaching the local yield stress level) followed by cycles with constant amplitude. A sequential finite element analysis (FEA) is performed thereby preserving the history of the elasto-plastic behavior. Both the welding process and the HFMI treatment are simulated using simplified approaches, i.e., the welding process is simulated by applying a simplified thermal cycle while the HFMI treatment is simulated by a quasi-static contact analysis. It is shown that using the simplified approaches to modelling both the welding process and HFMI treatment gives results that correlate qualitatively well with the experimental and FEA data available in the literature. Thus, for comparison purposes, simplified models may be sufficient. Both the use of the HFMI treatment and LTT electrodes give approximately the same compressive stress at the weld toe but the extent of the compressive stress zone is deeper for HFMI case. During cyclic loading it is shown that the beneficial effect of both methods will be substantially reduced if the test specimen is subjected to unexpected peak loads. For the chosen load sequence, with the same maximum local stress at the weld toe, the differences in stress curves of the HFMI-treated specimen and that with LTT electrodes remain. While the LTT electrode gives the lowest (compressive) stress right at the well toe, it is shown that the overall effect of the HFMI treatment is more beneficial.

Author

Lennart Josefson

Chalmers, Industrial and Materials Science, Material and Computational Mechanics

Jacob Alm

Chalmers, Industrial and Materials Science, Material and Computational Mechanics

J. M.J. McDill

Carleton University

Proceedings of the International Conference on Offshore Mechanics and Arctic Engineering - OMAE

Vol. 11B

ASME 2018 37th International Conference on Ocean, Offshore and Arctic Engineering, OMAE 2018
Madrid, Spain,

Subject Categories

Applied Mechanics

Manufacturing, Surface and Joining Technology

Other Materials Engineering

DOI

10.1115/OMAE2018-77401

More information

Latest update

3/21/2023