Simultaneous Frequency and Amplitude Estimation for Grid Quality Monitoring : New Partitioning with Memory Based Newton-Schulz Corrections

Paper in proceeding, 2022

High penetration level of renewable energy sources and introduction of controllable loads will result in significant harmonic emissions and sag and swell events in the future electricity networks. Development of the methods for high performance simultaneous estimation of the frequency and amplitude events is required for stable operation of the future electricity networks since zero crossing frequency detection method (which is widely used nowadays in industry) is not accurate enough and does not allow estimation of the amplitude events. The multiple model method which is suitable for simultaneous estimation of the frequency and amplitude is extended in this paper with introduction of a new decomposition technique based on stepwise partitioning, which allows simultaneous construction and accurate and computationally efficient inversion of the information matrix. Recursive calculations of the inverse introduce error accumulation and a new general high order memory based Newton-Schulz iteration is proposed in this paper for correction and reduction of the accumulated error. Moreover, parallel Richardson iterations which are based on partitioning method are proposed in this paper for reduction of the computational complexity. The methods are especially efficient for approximation of the signals with large number of harmonics. The approaches were tested for simultaneous estimation of the frequency and sag and swell signatures in the one-phase synchronized voltage waveform measured at the wall outlet. Simulation results show that the multiple model method provides more accurate frequency estimation in comparison to zero crossing method. In addition, the cascade multiple model method which is based on the multi-windowing technique (where the components of the signals are separated via a proper choice of the window sizes) is introduced in this paper for estimation of the significantly separated frequencies of the electrical signals. The approach was tested in the problem of frequency estimation using the measurement record from the electric vehicle with on-board charger connected to the supply voltage in the laboratory.