A two dimensional Euler–Lagrangian model of wood gasification in a charcoal bed—Part II: Parameter influence and comparison
Journal article, 2017

A Euler–Lagrangian simulation was employed for a comprehensive parameter study of wood gasification in a fluidized charcoal bed. The parameters that were varied include the initial bed temperature, fuel mass flow rate, inert tar fraction, and kinetic energy losses caused by particle–particle and particle–wall collisions. The results of each parameter variation are compared with a base scenario, previously described in detail in Part I of this study (Gerber & Oevermann, 2014). The results are interpreted by comparing the reactor outlet temperature, averaged particle temperature, overall wood mass, overall charcoal mass, concentrations of several gaseous species, and axial barycenter data for particles obtained with different sets of parameters. The inert tar fraction and fuel mass flow rate are the most sensitive parameter, while the particle–particle and particle–wall contact parameters have only a small impact on the results. Increasing the reactive tar components by 19% almost doubled the amount of reactive tars at the reactor outlet, while decreasing the restitution coefficients of the particle collisions by 0.2 results in higher overall gas production but almost no change in bed height. Herein, our numerical results are discussed in detail while assessing the model restrictions.

Wood gasification simulation

Gasification

Discrete element method

Charcoal

Pyrolysis

Gas–solid flow

Author

Stephan Gerber

Michael Oevermann

Chalmers, Applied Mechanics, Combustion and Propulsion Systems

Particuology

1674-2001 (ISSN) 22104291 (eISSN)

Vol. 35 22-30

Subject Categories

Mechanical Engineering

DOI

10.1016/j.partic.2017.01.004

More information

Created

1/2/2018 1