Accounting for product recovery potential in building life cycle assessments: a disassembly network-based approach
Journal article, 2024

Purpose: Existing life cycle assessment (LCA) methods for buildings often overlook the benefits of product recovery potential, whether for future reuse or repurposing. This oversight arises from the limited scope of such methods, which often ignore the complex interdependencies between building products. The present paper, backed by its supplementary Python library, introduces a method that addresses this gap, emphasizing the influence of product interdependencies and future recovery potential on environmental impact.

Methods: Implementing the proposed method requires adding a phase, the recovery potential assessment, to the four phases that constitute an LCA according to the ISO 14040/14044 guidelines. Given the disassembly sequence for each product, in the first step of the recovery potential assessment, a disassembly network (DN) is created that displays structural and accessibility dependencies. By calculating the average of the disassembly potential (DP) of each structural dependency (second step) associated with that product, we obtain the DP (0.1–1) at the product level in a third step. Because there is no empirical data available to support a specific relationship between product disassembly potential and recovery potential (RP) (0–1), we employ, in a fourth step, a flexible model specification to represent scenarios of how this relationship may look like. Ultimately, for each scenario, the resulting RP is used to enable a probabilistic material flow analysis with a binary outcome, whether to be recovered or not. The resulting product-level median material flows are then used to quantify the building’s environmental impact for a given impact category in the life cycle impact assessment (LCIA). The results are interpreted through an uncertainty, hotspot, and sensitivity analysis.

Results and discussion: Our results show that not considering the interdependencies between building products in building LCAs results in underestimating the embodied greenhouse gas (GHG) emissions by up to 28.29%. This discrepancy is primarily attributed to a failure to account for additional material flows stemming from secondary replacements owing to the interdependencies during the life cycle. When accounting for end-of-life recovery benefits, a zero-energy building (ZEB) design incorporating some DfD principles demonstrated up to 45.94% lower embodied GHG emissions than the ZEB design with low disassembly potential when assuming that recovered products will be reused.

Conclusions: Our approach provides first-of-a-kind evidence that not accounting for recovery potential may significantly distort the results of an LCA for buildings. The method and its supporting code support the semi-automated calculation of the otherwise neglected potential environmental impact, thus helping to drive the transition towards a more sustainable built environment. The supporting code allows researchers to build on the proposed framework if more data on the relationship between DP and RP become available in the future. Finally, while applied to buildings in this paper, the proposed framework is adaptable to any complex product with limited modifications in the supporting code.



ISO 20887:2020






Haitham Abu-Ghaida

Centre for Environmental Sciences

Michiel Ritzen

Flemish Institute for Technological Research

Alexander Hollberg

Chalmers, Architecture and Civil Engineering, Building Technology

S. Theißen

Institute of Building Information Modeling

Shady Attia

University of Liège

Sebastien Lizin

Centre for Environmental Sciences

International Journal of Life Cycle Assessment

0948-3349 (ISSN) 1614-7502 (eISSN)

Vol. In Press

Subject Categories

Environmental Management

Environmental Analysis and Construction Information Technology

Building Technologies



More information

Latest update