Polyethyleneoxide (PEO)-based, anion conducting solid polymer electrolyte for PEC solar cells
Paper i proceeding, 2008

Solid polymer electrolyte membranes were prepared by complexing tetrapropylammoniumiodide (Pr4N+I-) salt with polyethylene oxide (PEO) plasticized with ethylene carbonate (EC), and these were used in photoelectrochemical (PEC) solar cells fabricated with the configuration glass/FTO/TiO2/dye/electrolyte/Pt/FTO/glass. The PEO/Pr4N+I-+I-2=9:1 ratio gave the best room temperature conductivity for the electrolyte. For this composition, the plasticizer EC was added to increase the conductivity, and a further conductivity enhancement of four orders of magnitude was observed. An abrupt increase in conductivity occurs around 60-70 wt% EC; the room temperature conductivity was 5.4 x 10(-7) S cm(-1) for 60 wt% EC and 4.9 x 10(-5) S cm(-1) for the 70 wt% EC. For solar cells with electrolytes containing PEO/Pr4N+I-+I-2=9:1 and EC, IV curves and photocurrent action spectra were obtained. The photocurrent also increased with increasing amounts of EC, up to three orders of magnitude. However, the energy conversion efficiency of this cell was rather low.

ionic conductivity

solar cells

polymer electrolyte

sensitized

plasticizers

dye

Författare

T M W J Bandara

University of Rajarata

University of Peradeniya

MAKL Dissanayake

University of Peradeniya

O. A. Ileperuma

University of Peradeniya

K. Varaprathan

University of Peradeniya

K. Vignarooban

University of Peradeniya

Bengt-Erik Mellander

Chalmers, Teknisk fysik, Fasta tillståndets fysik

Journal of Solid State Electrochemistry

1432-8488 (ISSN)

Vol. 12 913-917

Ämneskategorier

Annan teknik

DOI

10.1007/s10008-007-0461-7