Characterization and mathematical modelling of single fluidised particle coating
Artikel i vetenskaplig tidskrift, 2011

A study was made of coating single particles with water-based dispersions under realistic fluid dynamic and well-defined operating conditions. The surfaces of the coated particles were observed with atomic force microscopy (AFM) and scanning electron microscopy (SEM). AFM was used to study the latex particle packing and the colloid particle coalescence at the nanoscale, while SEM was used to study the film at the droplet size level. The influence of temperature, moisture content and spray rate were investigated. The experiments showed a coating layer built up of rings of colloid particles for all cases studied except for high spray rate. A variation in the degree of coalescence between colloid particles with different glass transition temperatures, T-g, was shown in AFM. Cracks in the coating layer were observed when the temperature was lower than T-g. Mechanism evaluation using dimensionless numbers showed that a droplet will spread to the equilibrium angle without splashing; the colloid particles accumulate at the interface between the liquid and the air for all cases studied except air with 90% RH and 20 degrees C and a wet-bulb temperature in the coating layer. The evaluation indicated that no skin forms in any of the cases. A model of the drying of a single droplet was developed to describe the experimental results with rings of colloid particles. The simulation of the shape and height of the dried droplet agrees well with the experimental results. (C) 2010 Elsevier B.V. All rights reserved.


Fluidised bed

Latex dispersion








Single particle

latex film formation




Stina Karlsson

Chalmers University of Technology

Anders Rasmuson

Chalmers, Kemi- och bioteknik, Kemisk apparatteknik

I. N. Bjorn

AstraZeneca AB

S. Schantz

AstraZeneca AB

Powder Technology

0032-5910 (ISSN)

Vol. 207 245-256