Designing and operating a cold-flow model of a 100 kW chemical-looping combustor
Artikel i vetenskaplig tidskrift, 2012

This work presents the design and experimental evaluation of a cold-flow model system, built to simulate a 100 kW chemical-looping combustor for solid fuel. A theoretical background is provided, as well as some initial results using air as fluidization medium. The system has been operated for about 10 hours and shows no indication of imbalances in the bed inventories. In the fuel and air reactors, the mass fluxes were found to be linear in the riser pressure drop and the corresponding measured mass flows were approximately proportional to the mass flows calculated from the riser pressure drop. From the study of mass flows, residence times in both the fuel and air reactor were obtained. From pressure profile investigations, it was found that the system remained stable to changes in the fluidization velocity. Thus, both the internal circulation in the fuel reactor, and the circulation between air and fuel reactor, could be varied in a large range with only minor impact on the solids inventories of the air and fuel reactors.

Fluidization

Cold-flow model

Scaling

Dynamic similarity

Chemical-looping combustion

Författare

Pontus Markström

Chalmers, Energi och miljö, Energiteknik

Anders Lyngfelt

Chalmers, Energi och miljö, Energiteknik

Journal of Logic and Computation

0955-792X (ISSN) 1465-363X (eISSN)

Vol. 222 182-192

Drivkrafter

Hållbar utveckling

Ämneskategorier

Energiteknik

Övrig annan teknik

Styrkeområden

Energi

Fundament

Grundläggande vetenskaper

DOI

10.1016/j.powtec.2012.02.041