AMC pin waveguide flange for screw redundant millimeter and submillimeter measurements
Paper i proceeding, 2016

Measurements with waveguide flanges at frequencies above 100GHz have a considerable issue with leakage due to problems with achieving good electrical contact between the opposite flanges. The higher the frequency, the higher is the requirement for full contact. However, by using an artificial magnetic conducting (AMC) flange on one side of the interface, full electric contact is not needed between the two joining flanges. The AMC is realized as a pin-surface, and the leakage is stopped by a parallel-plate stopband like in gap waveguides. This paper describes how these AMC pin waveguide flanges can be used for screw redundant measurements.

Författare

Sofia Rahiminejad

Chalmers, Mikroteknologi och nanovetenskap, Elektronikmaterial

Elena Pucci

Chalmers, Signaler och system, Kommunikation, Antenner och Optiska Nätverk

Vessen Vassilev

Chalmers, Mikroteknologi och nanovetenskap, Mikrovågselektronik

Sjoerd Haasl

Chalmers, Mikroteknologi och nanovetenskap, Elektronikmaterial

Per-Simon Kildal

Chalmers, Signaler och system, Kommunikation, Antenner och Optiska Nätverk

Peter Enoksson

Chalmers, Mikroteknologi och nanovetenskap, Elektronikmaterial

87th ARFTG Microwave Measurement Conference: Measurements for Emerging Communications Technologies, ARFTG 2016

7501946-
978-1-5090-1308-1 (ISBN)

Styrkeområden

Informations- och kommunikationsteknik

Nanovetenskap och nanoteknik (SO 2010-2017, EI 2018-)

Transport

Drivkrafter

Innovation och entreprenörskap

Ämneskategorier

Kommunikationssystem

Nanoteknik

Infrastruktur

Nanotekniklaboratoriet

DOI

10.1109/ARFTG.2016.7501946

ISBN

978-1-5090-1308-1

Mer information

Senast uppdaterat

2021-09-07