Flow angularity investigations in an automotive slotted wall wind tunnel
Artikel i vetenskaplig tidskrift, 2019

The Volvo Cars aerodynamic wind tunnel has had a vortical flow angularity pattern in the test section since its original commissioning in 1986. The vortical flow nature persisted after an upgrade in 2006, when the fan was replaced and a moving ground system was introduced. It has been hypothesized that the cause for this flow angularity pattern was leakages around the heat exchanger installed in the settling chamber. The present paper tests this hypothesis by measuring the flow angularity in the test section before and after sealing the leakages. The findings show that the leakage path around the heat exchanger does not influence the flow angularity, and that the current pattern is different compared to the commissioning after the upgrade. This prompted an investigation of the influence from the turbulence screens, which were changed after the upgrade commissioning. These investigations indicate that the probable cause of the vortical flow angularity pattern is residual swirl from the fan. Force measurements on a reference car with and without extra induced flow angularity show that the flow angles measured in the tunnel for regular operation are most likely small enough to not have a significant effect on the measured aerodynamic forces.

slotted wall

wind tunnel

flow angularity

flow uniformity

Författare

Emil Ljungskog

Chalmers, Mekanik och maritima vetenskaper, Fordonsteknik och autonoma system

Simone Sebben

Chalmers, Mekanik och maritima vetenskaper, Fordonsteknik och autonoma system

Alexander Broniewicz

Volvo Cars

Energies

1996-1073 (ISSN)

Vol. 12 23 4575

Styrkeområden

Transport

Ämneskategorier

Farkostteknik

Strömningsmekanik och akustik

DOI

10.3390/en12234575

Mer information

Senast uppdaterat

2020-04-16