Surface integrity in micro-grinding of Ti6Al4V considering the specific micro-grinding energy
Paper i proceeding, 2020

Surface integrity is one of the most significant quality aspects of micro-grinding of difficult-to-cut materials. On the other hand, specific grinding energy is a fundamental parameter for describing the micro-grinding process. This paper addresses the surface integrity of the micro-ground surface of a titanium alloy under different cutting speeds and feed-rate-to-depth-of-cut (vw/ae) ratios at the same chip thickness. Three different cutting speeds and vw/ae ratios have been chosen and the residual stress of the workpiece, as well as the specific micro-grinding energy, have been investigated. The results showed that almost the same minimum specific grinding energy was obtained at tested cutting speed and vw/aeratio. The results of the XRD analysis showed that contrary to the specific micro-grinding energy, the residual stresses of the ground surface changed by varying the cutting speed and vw/ae ratio. Higher cutting speeds resulted in lower compressive residual stress, and higher vw/ae ratios resulted in higher compressive stresses. This can be attributed to higher temperatures in the chip-formation process compared to the plastic deformation in micro-grinding at higher cutting speeds and lower vw/ae ratios which was proved via SEM micrographs.

Grinding

Surface Integrity

Titanium alloy

Micro-grinding

Författare

Mohammadali Kadivar

Chalmers, Industri- och materialvetenskap, Material och tillverkning

Bahman Azarhoushang

Hochschule Furtwangen (HFU)

Amir Daneshi

Hochschule Furtwangen (HFU)

Peter Krajnik

Chalmers, Industri- och materialvetenskap, Material och tillverkning

Procedia CIRP

22128271 (eISSN)

Vol. 87 13-18

5th CIRP Conference on Surface Integrity, CSI 2020
, ,

Styrkeområden

Produktion

Ämneskategorier

Bearbetnings-, yt- och fogningsteknik

DOI

10.1016/j.procir.2020.02.069

Mer information

Senast uppdaterat

2021-01-04