Variation simulation of sheet metal assemblies using the method of influence coefficients with contact modeling
Artikel i vetenskaplig tidskrift, 2007

Sheet metal assembly is a common assembly process for several products such as automobiles and airplanes. Since all manufacturing processes are affected by variation, and products need to have a high geometric quality, geometry-related production problems must be analyzed during early design phases. This paper discusses two methods of performing this analysis. One way of performing the simulations relatively fast is to establish linear relationships between part deviation and assembly springback deviation by using the method of influence coefficient (MIC). However, this method does not consider contact between the parts. This means that the parts are allowed to penetrate each other which can affect the accuracy of the simulation result. This paper presents a simple contact modeling technique that can be implemented in to MIC to avoid penetrations. The contact modeling consists of a contact detection and a contact equilibrium search algorithm. When implemented, MIC still only requires two finite element analysis (FEA) calculations. This paper describes the steps in the contact algorithm and how it can be used in MIC and finally the proposed contact modeling is verified by comparing the simulation result with commercial FEA software ABAQUS contact algorithm.

contact modeling

variation simulation

PARTS

COMPLIANT

tolerance analysis

sheet metal assemblies

Författare

Stefan Dahlström

Chalmers, Produkt- och produktionsutveckling, Produktutveckling

Lars Lindkvist

Chalmers, Produkt- och produktionsutveckling, Produktutveckling

Journal of Manufacturing Science and Engineering, Transactions of the ASME

1087-1357 (ISSN)

Vol. 129 3 615-622

Ämneskategorier

Övrig annan teknik

DOI

10.1115/1.2714570