Wear Behaviour Related to Microstructure of Ni3Al-Based Alloys
Poster (konferens), 2006

A number of laboratory studies have indicated that Ni3Al-based alloys have significant potential in wear-critical applications, especially in sliding wear in a temperature range of between 400 ºC - 650 ºC. In this study, the wear behavior of an iron-alloyed Ni3Al with composition of Ni-18.8Al-10.7Fe-0.5Mn-0.5Ti-0.2B in atomic percentage and its composites reinforced by 6 vol. % Cr3C2-particles were investigated. Hot isostatic pressing (HIP) and casting processes were applied for preparing the materials. The wear rate of the tested materials under different loads and their scuffing resistance were measured by means of the Pin-on-Disk method. Analytical SEM, EDS, and XRD techniques were used to observe the microstructures and identify the phase constitutions of the materials. The tribological performance related to the analytical results revealed that the single phase Ni3Al-based alloy showed an improved scuffing resistance, compared to a duplex phase microstructure. Also, the investigation indicated that the added hard Cr-carbide played a positive role for the tribological behavior of the intermetallics, especially in terms of reducing the wear rate.

Nickel aluminide

Wear-resistant materials

Key words: Intermetallics

Sliding wear

Scuffing

Författare

Karin Anne Xia Gong

Chalmers, Material- och tillverkningsteknik, Yt- och mikrostrukturteknik

Materials Research Society Symposium Proceedings Volume 980

Vol. 980

Ämneskategorier

Materialteknik

Styrkeområden

Materialvetenskap

Mer information

Skapat

2017-10-08