Surface roughness impact on secondary flow and losses in a turbine exhaust casing

Paper i proceeding, 2018

This paper experimentally addresses the impact of surface roughness on losses and secondary flow in a Turbine Rear Structure (TRS). Experiments were performed in the Chalmers LPTOGV facility, at an engine representative Reynolds number with a realistic shrouded rotating low-pressure turbine (LPT). Outlet Guide Vanes (OGV) were manufactured to achieve three different surface roughnesses tested at two Reynolds numbers, Re = 235000 and Re = 465000. The experiments were performed at on-design inlet swirl conditions. The inlet and outlet flow of the TRS were measured in 2D planes with a 5-hole probe and 7-hole probe accordingly. The static pressure distributions on the OGVs were measured and boundary layer studies were performed at the OGV midspan on the suction side with a time-resolved total pressure probe. Turbulence decay was measured within the TRS with a single hot-wire. The results showed a surprisingly significant increase in the losses for the high level of surface roughness (25-30 Ra) of the OGVs and Re = 465000. The increased losses were primary revealed as a result of the flow separation on the OGV suction side near the hub. The loss increase was seen but was less substantial for the intermediate roughness case (4-8 Ra). Experimental results presented in this work provide support for the further development of more advanced TRS and data for the validation of new CFD prediction methods for TRS.