Design of microwave circuits in ridge gap waveguide technology
Paper in proceedings, 2010

This paper presents recent advances is a new waveguiding technology referred to as ridge gap waveguides. The main advantages of the ridge gap waveguides compared to hollow waveguides are that they are planar and much cheaper to manufacture, in particular at high frequencies such as for millimeter and submillimeter waves. In these waveguides there are no mechanical joints across which electric currents must float. The gap waveguides have lower losses than microstrip lines, and they are completely shielded by metal so no additional packaging is needed, in contrast to the severe packaging problems associated with microstrip circuits. The gap waveguides are realized in a narrow gap between two parallel metal plates by using a texture on one of the surfaces. The waves follow metal ridges in the textured surface. All wave propagation in other directions is prohibited (in cutoff) by realizing a high impedance (ideally a perfect magnetic conductor) through the textured surface at both sides of all ridges. Thereby, cavity resonances do not appear within the band of operation. The paper studies the characteristic impedance of the line and presents simulations and measurements of circuits designed using this technology.

Author

E. Alfonso

Polytechnic University of Valencia (UPV)

Mariano Baquero

Polytechnic University of Valencia (UPV)

Per-Simon Kildal

Chalmers, Signals and Systems, Communication and Antenna Systems, Antennas

A. Valero-Nogueira

Polytechnic University of Valencia (UPV)

Eva Rajo

Chalmers, Signals and Systems, Communication and Antenna Systems, Antennas

J. I. Herranz

Polytechnic University of Valencia (UPV)

IEEE MTT-S International Microwave Symposium Digest

0149645X (ISSN)

1544 - 1547 5514731

Subject Categories

Electrical Engineering, Electronic Engineering, Information Engineering

DOI

10.1109/MWSYM.2010.5514731

ISBN

978-1-4244-6056-4

More information

Latest update

3/6/2018 1