Design of microwave circuits in ridge gap waveguide technology
Paper i proceeding, 2010

This paper presents recent advances is a new waveguiding technology referred to as ridge gap waveguides. The main advantages of the ridge gap waveguides compared to hollow waveguides are that they are planar and much cheaper to manufacture, in particular at high frequencies such as for millimeter and submillimeter waves. In these waveguides there are no mechanical joints across which electric currents must float. The gap waveguides have lower losses than microstrip lines, and they are completely shielded by metal so no additional packaging is needed, in contrast to the severe packaging problems associated with microstrip circuits. The gap waveguides are realized in a narrow gap between two parallel metal plates by using a texture on one of the surfaces. The waves follow metal ridges in the textured surface. All wave propagation in other directions is prohibited (in cutoff) by realizing a high impedance (ideally a perfect magnetic conductor) through the textured surface at both sides of all ridges. Thereby, cavity resonances do not appear within the band of operation. The paper studies the characteristic impedance of the line and presents simulations and measurements of circuits designed using this technology.

Författare

E. Alfonso

Universitat Politecnica de Valencia (UPV)

Mariano Baquero

Universitat Politecnica de Valencia (UPV)

Per-Simon Kildal

Chalmers, Signaler och system, Kommunikation, Antenner och Optiska Nätverk

A. Valero-Nogueira

Universitat Politecnica de Valencia (UPV)

Eva Rajo

Chalmers, Signaler och system, Kommunikation, Antenner och Optiska Nätverk

J. I. Herranz

Universitat Politecnica de Valencia (UPV)

IEEE MTT-S International Microwave Symposium Digest

0149645X (ISSN)

1544 - 1547 5514731
978-1-4244-6056-4 (ISBN)

Ämneskategorier

Elektroteknik och elektronik

DOI

10.1109/MWSYM.2010.5514731

ISBN

978-1-4244-6056-4

Mer information

Senast uppdaterat

2018-03-06