Inter-Channel Interference Cancellation for Long-Haul Superchannel System

Journal article, 2024

Optical frequency combs enable superchannel systems with dense channel spacing by providing equally-spaced lines to overcome the relative frequency drifts of free-running lasers, achieving high spectral efficiency. However, strong inter-channel interference is induced in densely spaced systems due to imperfect pulse-shaping, preventing the further improvement of system throughput. By including the spectra information from the adjacent channels, comb-based multi-channel equalization has been previously validated in a back-to-back and 80 km transmission system for linear crosstalk mitigation. In this case, the limiting factor of the system was the effective number of bits (ENOB). Here, we investigate the influence of amplified spontaneous emission noise and the effectiveness of joint equalization in long-haul transmission systems. We show that the performance of the multi-channel equalizer (MCE) is significantly degraded when reducing the optical-signal-to-noise ratio (OSNR), especially for high-order modulation formats, in both noise-loading and long-distance transmission experiments. Moreover, the ASE noise from the neighboring channels can be coupled into the systems by the MCE, degrading the performance improvement. We find that a large-tap MCE can maximize the system performance in the high OSNRs, whereas MCE with a smaller tap should be applied in low OSNRs to alleviate the effect of ASE noise. After transmission of 800 km, an AIR increase of more than 0.1 bits/s/Hz is enabled by the optimized MCE for 16-QAM and 64-QAM. Our results confirm the validity of the joint equalization gain for short-distance transmission but also clearly demonstrate the performance penalty originating from transmission optical noise. Moreover, the equalizer tap number needs to be optimized for each OSNR to maximize the performance of joint equalization. We believe this limitation is also valid for other impairments such as optical noise in the comb and electrical noise in the transceiver.