A friction model evaluated with results from a bending-under-tension test
Artikel i vetenskaplig tidskrift, 2009

The friction in stamping is an important process parameter to control the flow of material in the tool. Consequently, it is also an important parameter in the design process of new stamping tools when numerical simulations of the forming operations are performed. In this work an advanced friction model is evaluated. which considers properties of surface topography, lubricant, sheet material, and process parameters such as sliding speed and pressure. The evaluation is made by comparing theoretical results with experimental ones obtained in a bending-under-tension friction test. The results show conformance in behaviour between the friction model and the experimental work. Furthermore, a model, which considers the influence of bulk plastic strains on the real area of contact, is investigated. The developed model predicts that the effective hardness of a surface is reduced by the presence of underlying plastic flow. it is found that when the strain rates are increased, the Stribeck curve becomes flatter and mixed lubrication is introduced at lower Hersey values. The friction model clearly shows the potential of improving the FE simulations of sheet metal forming operations, in comparison to the use of the classical Coulomb's friction model.

Sheet metal forming

area

contact

Friction

Surface topography

simulation

sheet-metal

Författare

Daniel Wiklund

Chalmers, Material- och tillverkningsteknik, Tillverkningsteknik

Bengt-Göran Rosen

Chalmers, Material- och tillverkningsteknik, Tillverkningsteknik

A. Wihlborg

Volvo

Tribology International

0301-679X (ISSN)

Vol. 42 10 1448-1452

Ämneskategorier

Maskinteknik

DOI

10.1016/j.triboint.2009.05.008

Mer information

Skapat

2017-10-06