Numerical studies of bandwidth of parallel-plate cut-off realised by a bed of nails, corrugations and mushroom-type electromagnetic bandgap for use in gap waveguides
Artikel i vetenskaplig tidskrift, 2011

Recently it has been shown that so-called gap waveguides can be generated in the gap between parallel metal plates. The gap waveguides are formed by metal ridges or strips along which local waves propagate, and parallel plate modes are prohibited from propagating by providing one of the surfaces with a texture that generates an artificial magnetic conductor (AMC) or an electromagnetic bandgap (EBG) surface on both sides of the ridges or strips. The bandwidth of the gap waveguide is determined by the cut-off bandwidth of a parallel-plate waveguide where one surface has such a texture (and no ridges or strips). This paper studies the bandwidths (or stop bands) of such parallel-plate cut-offs when the AMC or EBG is realised by a metal pin surface, corrugations or a mushroom surface. It is shown that cut-off bandwidths of up to 4:1 are potentially available, and thereby similar bandwidths should be achievable also for gap waveguides.

soft

hard surfaces

Författare

Eva Rajo

Universidad Carlos III de Madrid

Per-Simon Kildal

Chalmers, Signaler och system, Kommunikation, Antenner och Optiska Nätverk

IET Microwaves, Antennas and Propagation

1751-8725 (ISSN) 17518733 (eISSN)

Vol. 5 3 282-289

Styrkeområden

Informations- och kommunikationsteknik

Ämneskategorier

Elektroteknik och elektronik

DOI

10.1049/iet-map.2010.0073

Mer information

Senast uppdaterat

2018-03-23