A new design model for adhesive joints used to bond FRP laminates to steel beams Part B: Experimental verification
Artikel i vetenskaplig tidskrift, 2012

A new design model for adhesive joints used to bond fiber reinforced polymer, FRP, laminates to steel beams was presented in part A of this paper. Quasi-static tests were performed on representative and full-scale beam specimens to evaluate some of the most important failure criteria discussed in part A and the new design model proposed in this study. Three strengthening systems, from two manufacturers (Sika (R) and STO (R)), were used to prepare the specimens. It was observed that, in all cases, the failure took place at the steel-adhesive interface. It was found that, failure criteria based on material strength, considered in this study, fail to provide reasonable predictions of the strength of joints. The new design model presented in part A of this paper was found to be accurate in terms of predicting the ultimate load and failure mode of the joints.

Laminate

Steel

Adhesive joint

Flexural

FRP

stresses

Design

Författare

Reza Haghani Dogaheh

Chalmers, Bygg- och miljöteknik, Konstruktionsteknik

Mohammad Al-Emrani

Chalmers, Bygg- och miljöteknik, Konstruktionsteknik

Construction and Building Materials

0950-0618 (ISSN)

Vol. 30 686-694

Ämneskategorier

Husbyggnad

DOI

10.1016/j.conbuildmat.2011.12.005

Mer information

Skapat

2017-10-06