An experimental investigation of temperature and machinability in turning of compacted graphite irons
Artikel i vetenskaplig tidskrift, 2012

The life and the performance of an insert in metal cutting are mainly dependent on the heat that is generated in the contact zones on the tool rake face with chips and on the flank face with the transient and machined surfaces. According to tool life standard, the wear on the flank face is usually taken as a decision for tool life. This occurs because of contact stresses, temperature and friction between tool workpiece contacts. Hence, knowledge of temperature on the flank face becomes important. The temperature on the flank face has been measured in this work for different CGI materials having different microstructure and physical properties in a turning operation. It has been seen that there is no significant difference of flank temperature, while machining different CGI materials having hardness from (140 to 236 HBW). For temperature measurement, special inserts integrated with gold-platinum thermocouple on the flank face were used. It has been noticed that the materials having 31% resultant cutting force difference and six to eight times tool life difference have almost same temperature on the flank face measured at different distances from the edge line of the insert.

compacted graphite iron

tool life

CGI

cutting

flank temperature

Författare

Varun Nayyar

Chalmers, Material- och tillverkningsteknik, Tillverkningsteknik

Jacek K Kaminski

Chalmers, Material- och tillverkningsteknik, Tillverkningsteknik

Anders Kinnander

Chalmers, Material- och tillverkningsteknik, Tillverkningsteknik

Lars Nyborg

Chalmers, Material- och tillverkningsteknik

Internatinal Journal of Materials and Product Technology

1741-5209 (ISSN)

Vol. 43 102-121

Ämneskategorier

Produktionsteknik, arbetsvetenskap och ergonomi

Styrkeområden

Materialvetenskap

DOI

10.1504/IJMPT.2012.047637