Ship hull in-water cleaning and its effects on fouling-control coatings
Artikel i vetenskaplig tidskrift, 2020

Today, ship hull fouling is managed through fouling-control coatings, complemented with inwater cleaning. During cleaning, coating damage and wear must be avoided, for maximum coating lifetime and reduced antifoulant release. When possible, cleaning should target early stages of fouling, using minimal forces. However, such forces, and their effects on coatings, have not yet been fully quantified. In this one-year study, minimal cleaning forces were determined using a newly-designed immersed waterjet. The results show that bi-monthly/monthly cleaning, with maximum wall shear stress up to 1.3 kPa and jet stagnation pressure 0.17 MPa, did not appear to cause damage or wear on either the biocidal antifouling (AF) or the biocide-free foul-release (FR) coatings. The AF coating required bi-monthly cleanings to keep fouling to incipient slime (time-averaged results), while the FR coating had a similar fouling level even without cleaning. The reported forces may be used in matching cleaning parameters to the adhesion strength of the early stages of fouling.

energy efficiency

fouling control coatings

calibrated waterjet

Adhesion strength

microfouling

ship hull fouling

Författare

Dinis Oliveira

Chalmers, Mekanik och maritima vetenskaper, Maritima studier

Lena Granhag

Chalmers, Mekanik och maritima vetenskaper, Maritima studier

Biofouling

0892-7014 (ISSN) 1029-2454 (eISSN)

Vol. 36 3 332-350

Completing management options in the Baltic Sea Region to reduce risk of invasive species introduction by shipping COMPLETE

Interreg (#R069 COMPLETE), 2017-10-01 -- 2020-09-30.

Ämneskategorier

Energiteknik

Bearbetnings-, yt- och fogningsteknik

Miljöledning

Tillförlitlighets- och kvalitetsteknik

Infrastruktur

Chalmers materialanalyslaboratorium

DOI

10.1080/08927014.2020.1762079

Mer information

Senast uppdaterat

2020-06-10