A detailed microstructural and corrosion analysis of magnesium alloy WE43 manufactured by selective laser melting
Artikel i vetenskaplig tidskrift, 2020
The production of magnesium alloy WE43 was achieved by selective laser melting (SLM). The alloy was investigated after SLM, hot isostatic pressing (HIP), and solutionising heat treatment. The microstructure and corrosion behaviour of the specimens were carefully characterised, whilst assessed and contrast relative to the conventionally cast alloy counterpart. The SLM prepared specimens possess a unique microstructure comprising fine grains growing with a strong [0001] texture along the building direction with a low fraction of process-induced and metallurgical defects, reaching < 0.1 %, after optimising the SLM parameters and the HIP treatment. Electrochemical measurements demonstrated that the SLM prepared WE43 is cathodically more active as compared with its cast counterpart. It is proposed that this behaviour is due to a high density of zirconium-rich oxide particles uniformly distributed throughout the alloy microstructure as well as the alterations in the chemical composition of the solid-solution matrix originating from the high cooling rates of SLM. It was also noted that the oxide particles are mainly sourced by powder. The present results suggest that the corrosion of SLM prepared Mg alloys could be greatly improved once the influence of powder characteristics is further understood and controlled.
Selective laser meltingMagnesium alloyWE43CorrosionMicrostructure
Författare
M. Esmaily
Massachusetts Institute of Technology (MIT)
Monash University
Z. Zeng
Monash University
Anna Mortazavi
Harvard University
Monash University
A. Gullino
Monash University
Politecnico di Torino
S. Choudhary
Monash University
T. Derra
Meotec GmbH
F. Benn
Meotec GmbH
F. D'Elia
Meotec GmbH
M. Müther
Meotec GmbH
S. Thomas
Monash University
A. Huang
Monash University
A. Allanore
Massachusetts Institute of Technology (MIT)
A. Kopp
Meotec GmbH
Nick Birbilis
Australian National University
Additive Manufacturing
2214-8604 (eISSN)
Vol. 35 101321Ämneskategorier
Annan kemi
Metallurgi och metalliska material
Korrosionsteknik
DOI
10.1016/j.addma.2020.101321