Manufacturing of tooth coil winding PM machines with in-slot oil cooling
Paper i proceeding, 2020

This paper presents a description of the manufacturing challenges and solutions of two 50 kW radial flux inner-rotor tooth coil winding PM machines with in-slot cooling for vehicle application. The two machines are designed for different DC link voltages, 600 V and 48 V, and to achieve high efficiency and high power density. To enable this, liquid cooling is necessary. In the solution presented, the oil coolant is pushed through the stator yoke and in the slots with the intent of removing the heat close to the loss generation. The cooling channels in the slots are built during the stator potting process using a high thermally conductive potting material. The machines presented in this paper are designed for high speed operation and capable to withstand RMS current densities of 25 A/mm2 in continuous operation and 35 A/mm2 for 30 s peaks, at 6 1/min oil flow and a inlet temperature of 20oC. It is shown that stator is designed to be compatible with automated manufacturing for high volume production with a set of suggested improvements.

tooth coil winding

pm machine

electrical vehicle

Författare

Alessandro Acquaviva

Chalmers, Elektroteknik, Elkraftteknik

Stefan Skoog

Chalmers, Elektroteknik, Elkraftteknik

Torbjörn Thiringer

Chalmers, Elektroteknik, Elkraftteknik

Proceedings - 2020 International Conference on Electrical Machines, ICEM 2020

2314-2320 9270747
978-172819945-0 (ISBN)

2020 International Conference on Electrical Machines (ICEM)
Virutal, Göteborg, Sweden,

Styrkeområden

Transport

Energi

Ämneskategorier

Elektroteknik och elektronik

DOI

10.1109/ICEM49940.2020.9270747

ISBN

9781728199450

Mer information

Senast uppdaterat

2023-04-21