Effect of cuting parameters on the generated surface integrity of hard-turned martensitic AISI 52100 bearing steel
Paper i proceeding, 2022
Hard turning offers improved manufacturing efficiency but requires great control of the cutting process to achieve the required machining-induced surface integrity with respect to residual stresses, surface topography, and near-surface microstructure. This research work is focused on studying the effect of the cutting speed, feed rate, depth of cut, chamfer angle, and coolant pressure on the surface integrity after hard turning of martensitic AISI 52100 steel. The results showed that the feed rate had a signinficant influence on the residual stresses and the surface topography. The discontinuous mechanically induced white layer was observed at high cutting speed and high chamfer angle with increased thickness.
surface topography
white layer
Hard turning
residual stress
surface integrity
Författare
Sahith Kokkirala
Chalmers, Industri- och materialvetenskap, Material och tillverkning
Jonas Holmberg
RISE Research Institutes of Sweden
Uta Klement
Chalmers, Industri- och materialvetenskap, Material och tillverkning
Roger Lundstrom
SKF Group
Hirotsugu Iwasaki
Sumitomo Electric Hartmetall GmbH
Seyed Hosseini
Chalmers, Industri- och materialvetenskap, Material och tillverkning
RISE Research Institutes of Sweden
Procedia CIRP
22128271 (ISSN)
Vol. 115 154-159
10th CIRP Global Web Conference on Material Aspects of Manufacturing Processes
Gothenburg, Sweden,
Gothenburg, Sweden,
Flexibel och hållbar tillverkning av högpresterande rullningslager
VINNOVA (2021-01274), 2021-06-16 -- 2024-03-31.
Ämneskategorier (SSIF 2011)
Materialteknik
Bearbetnings-, yt- och fogningsteknik
Styrkeområden
Produktion
DOI
10.1016/j.procir.2022.10.066