Top-Down Decomposition of Multi-Product Requirements onto Locator Tolerances
Paper i proceeding, 2007

The tolerance allocation problem consists of choosing tolerances on dimensions of a complex assembly so that they combine into an ‘optimal state’ while fulfilling certain requirements on an allowed variation. This optimal state often coincides with the minimum manufacturing cost of the product. Sometimes it is balanced with an artificial cost that the deviation from target induces on the quality of the product. This paper suggests a multiobjective formulation of the tolerance allocation problem to automatically decompose requirements for an allowed variation on a set of critical product dimensions. This formulation is demonstrated using a rear lamp on a car with multiple requirements on allowed variation. In this case only the tolerances on locators that locates the lamp on the body are considered. The paper also reviews a selection of work that has been made on solving tolerance allocation problems.

Tolerance allocation

variation simulation

tolerance analysis

Författare

Johan Lööf

Chalmers, Produkt- och produktionsutveckling, Produktutveckling

Rikard Söderberg

Chalmers, Produkt- och produktionsutveckling, Produktutveckling

Proceedings of IMECE2007, 2007 ASME International Mechanical Engineering Congress and Exposition, November 11-15, 2007, Seattle, Washington, USA.

Vol. 3 247-255

Ämneskategorier

Maskinteknik

Beräkningsmatematik

Övrig annan teknik

Annan matematik

DOI

10.1115/IMECE200743453

ISBN

0791842975

Mer information

Skapat

2017-10-07