A Fixture Failure Control Chart For Variation Caused By Assembly Fixtures
Paper i proceeding, 2012

In the auto body assembly process, fixtures are used to position parts during assembly and inspection. If there is variation in the positioning process, this will propagate to the final assembly. There are also other sources of variation in the final assembly, such as variation in parts due to previous manufacturing steps. To facilitate the separation of the different sources of variation, and thereby also improve fault diagnosis, a fixture failure subspace control chart is proposed. This control chart is based on a multivariate T2-chart, but only variations in the fixture failure subspace are considered. The method is applied to two industrial case studies with satisfying results.

T2-chart

Quality Control

Fixtures

Assembly

Multivariate

Författare

Kristina Wärmefjord

Chalmers, Produkt- och produktionsutveckling, Produktutveckling

Johan Carlson

Chalmers, Produkt- och produktionsutveckling, Produktutveckling

roceedings of the ASME 2012 International Mechanical Engineering Congress & Exposition, IMECE2012, Houston, Texas, USA

Vol. 3 PARTS A, B, AND C 1807-1814
9780791845196 (ISBN)

Ämneskategorier

Produktionsteknik, arbetsvetenskap och ergonomi

Tillförlitlighets- och kvalitetsteknik

Drivkrafter

Hållbar utveckling

Styrkeområden

Produktion

DOI

10.1115/IMECE2012-86257

ISBN

9780791845196

Mer information

Senast uppdaterat

2024-07-12