High Voltage Driver for RSFQ Digital Signal Processor
Artikel i vetenskaplig tidskrift, 2007

We present an RSFQ based high voltage driver (HVD) developed for the first amplification stage of the hybrid semiconductor-superconductor memory interface for the RSFQ digital signal processor. Implementation of the driver allows to eliminate the impedance mismatch between the RSFQ and standard 50 Ω input of the semiconductor electronics and increases the signal-to-noise ratio to reach reliable signal transmission with sufficiently low bit error rate. This driver can produce output signal of NRZ pulses at 1 Gbit/s speed and 2.4 mV signal level that is enough to be sensed by LNA on the further amplification stage. The driver was simulated numerically in PSCAN. The driver design is based on the serial stack of 8 SQUIDs with specially configured ground-cuts that form a quasi-coplanar line with 50 Ω impedance. The impedance of the driver has been extracted using 3D EM simulators that accurately take into account multilayer structure and capacitance to the ground. The circuit has been designed for the standard Hypres 4.5 kA/cm2 process. Numerical simulation results are presented and discussed.

RSFQ driver

RSFQ

quasi-coplanar line.

LNA

Författare

Igor Soloviev

Moscow State University

Raihan Rafique

Fasta tillståndets elektronik

Henrik Engseth

Fasta tillståndets elektronik

Anna Kidiyarova-Shevchenko

Chalmers

IEEE Transactions on Applied Superconductivity

1051-8223 (ISSN) 15582515 (eISSN)

Vol. 17 2 470-473

Ämneskategorier

Annan teknik

DOI

10.1109/TASC.2007.898070

Mer information

Senast uppdaterat

2018-09-10