Analytical models for initial and intermediate stages of sintering of additively manufactured stainless steel
Artikel i vetenskaplig tidskrift, 2023

In isotropic pressure-less sintering continuum mechanics models, densification kinetics is driven by the balance between the effective sintering stress and bulk viscosity. In components manufactured by binder jetting (BJ), the green structure created by the arrangement of spherical powder particles during printing is characterized by its high porosity (40–50%). This leads to a wide porosity range for the initial and intermediate sintering stages, where a complex combination of diffusion mechanisms drives matter redistribution through the porous compact. In this paper, a comprehensive analysis of the porosity effect on the resistance to densification of 316L BJ during sintering was performed by avoiding other highly influencing factors like δ-ferrite phase transformation. Different normalized bulk moduli expressions, inspired by Skorohod, Hsueh, and Abouaf sintering models, are used in the framework of the continuum theory of sintering. A new material constants determination algorithm based on the sintering experiments design and non-linear analysis of the model was proposed. This evidenced the critical importance of the experimental data collection for the determination of the required sintering model constants. Accordingly, material shear viscosity and normalized bulk viscosity constants were successfully determined based on dilatometry and grain size experimental data. The bulk moduli proposed comprise physical parameters which depend on the interparticle stress distribution or the initial high reactivity of the BJ compacts. The variation of powder size distribution and/or arrangement would potentially impact the determination of these constants in the normalized bulk moduli.

Sintering

Additive manufacturing

Binder jetting

Shrinkage

Stainless steel

Författare

Alberto Cabo Rios

San Diego State University

Chalmers, Industri- och materialvetenskap, Material och tillverkning

Eugene Olevsky

San Diego State University

University of California at San Diego (UCSD)

Eduard Hryha

Chalmers, Industri- och materialvetenskap, Material och tillverkning

Mats Persson

Höganäs

Rajendra K. Bordia

Clemson University

Acta Materialia

1359-6454 (ISSN)

Vol. 249 118822

Ämneskategorier

Teknisk mekanik

Keramteknik

Annan materialteknik

DOI

10.1016/j.actamat.2023.118822

Mer information

Senast uppdaterat

2023-03-23