Flow Behaviour of Anisotropic Conductive Adhesive Film during COG Bonding Process in Flat Panel Display Assembly
Paper i proceeding, 2006

Anisotropic conductive adhesives have emerged as an important joining technology in a number of significant application areas, such as fine pitched driver IC for flat panel display assembly and smart cards. In the past research work in this field, it has been shown that the pressure distribution and adhesive compression flow predicted using the Newtonian and non-Newtonian FV models both agree closely with those from the previously developed analytical model. This gives confidence in the FV modelling approach and therefore the results predicted more complex situations which the analytical model cannot address. These results further confirm that a more sophisticated modelling approach is required in order to allow a full understanding about the effects of the assembly process on its final properties when the adhesive flows. An analytical model has been proposed in this paper which takes into account more complex bump geometry and can be used to predict the velocity and pressure drop distribution through the entire chip during the COG bonding process. The analytical solution is followed by the finite element modelling, which agrees well with the analytically predicted solution.

Författare

Fabien Raugi

Chalmers

Mohammad Kamruzzaman Chowdhury

Chalmers

Helge Kristiansen

Conpart AS

Johan Liu

Chalmers, Mikroteknologi och nanovetenskap, Fasta tillståndets elektronik

1st Electronics Systemintegration Technology Conference; Dresden, Saxony; Germany; 5 September 2006 through 7 September 2006

Vol. 2 828-833
1424405521 (ISBN)

Ämneskategorier

Elektroteknik och elektronik

DOI

10.1109/ESTC.2006.280107

ISBN

1424405521

Mer information

Senast uppdaterat

2024-07-12