Nitrogen uptake of nickel free austenitic stainless steel powder during heat treatment-an XPS study
Artikel i vetenskaplig tidskrift, 2015

In austenitic stainless steel nitrogen stabilizes the austenitic phase, improves the mechanical properties and increases the corrosion resistance. Nitrogen alloying enables to produce austenitic steels without the element nickel which is high priced and classified as allergy inducing. A novel production route is nitrogen alloying of CrMn-prealloyed steel powder via the gas phase. This is beneficial as the nitrogen content can be adjusted above the amount that is reached during conventional casting. A problem which has to be overcome is the oxide layer present on the powder surface which impedes both the sintering process and the uptake of nitrogen. This study focuses on whether heat treatment under pure nitrogen is an appropriate procedure to enable sintering and nitrogen uptake by reduction of surface oxides. X-ray photoelectron spectroscopy (XPS) in combination with scanning electron microscopy (SEM) and energy dispersive X-ray spectrometry (EDS) are used to investigate the surface of powdered FeMn19Cr17C0.4N heat treated under nitrogen atmosphere. The analyses showed reduction of iron oxides already at 500 degrees C leading to oxide-free metallic surface zones. Mn and Cr oxides are reduced at higher temperatures. Distinct nitrogen uptake was registered, and successful subsequent sintering was reached.

nitrogen uptake


nitrogen alloying

powder metallurgy


stainless steel


Anna Weddeling

Ruhr-Universitat Bochum

K. Lefor

Ruhr-Universitat Bochum

Eduard Hryha

Chalmers, Material- och tillverkningsteknik, Yt- och mikrostrukturteknik

Stephan Huth

Ruhr-Universitat Bochum

Lars Nyborg

Chalmers, Material- och tillverkningsteknik

Sebastian Weber

Bergische Universität Wuppertal

W. Theisen

Ruhr-Universitat Bochum

Surface and Interface Analysis

0142-2421 (ISSN) 1096-9918 (eISSN)

Vol. 47 413-422


Hållbar utveckling


Fysikalisk kemi

Metallurgi och metalliska material