Validating material modelling for OFHC copper using Dynamic Tensile Extrusion (DTE) test at different velocity impact
Paper i proceeding, 2017

In the Dynamic Tensile Extrusion (DTE) test, the material is subjected to very large strain, high strain rate and elevated temperature. Numerical simulation, validated comparing with measurements obtained on soft-recovered extruded fragments, can be used to probe material response under such extreme conditions and to assess constitutive models. In this work, the results of a parametric investigation on the simulation of DTE test of annealed OFHC copper -at impact velocity ranging from 350 up to 420 m/s -using the modified Rusinek-Klepaczko model, are presented. Simulation of microstructure evolution was performed using the visco-plastic self consistent model (VPSC), providing, as input, the velocity gradient history obtained with FEM at selected locations along the axis of the fragment trapped in the extrusion die. Finally, results are compared with EBSD analysis.

Författare

Nicola Bonora

Universita di Cassino e del Lazio Meridionale

Gabriel Testa

Universita di Cassino e del Lazio Meridionale

Andrew Ruggiero

Universita di Cassino e del Lazio Meridionale

G. Iannitti

TECHDYN Engineering

Magnus Hörnqvist Colliander

Chalmers, Fysik, Materialens mikrostruktur

Nooshin Mortazavi Seyedeh

Chalmers, Fysik, Materialens mikrostruktur

AIP Conference Proceedings

0094-243X (ISSN) 1551-7616 (eISSN)

Vol. 1793 100019- 100019

Ämneskategorier

Maskinteknik

DOI

10.1063/1.4971644

Mer information

Senast uppdaterat

2018-11-06