A Generic DFIG Model for Voltage Dip Ride-Through Analysis
Artikel i vetenskaplig tidskrift, 2013

The modeling of a Doubly fed induction generator (DFIG) system for a wind turbine application is investigated in this paper. The electrical generating system is equipped with a dc crowbar system for fault ride through ability. After setting up the basic machine, converter, and grid-filter equations, the various controllers are derived and the selection of the regulator parameters is discussed. To validate the derived model, the investigated DFIG system is simulated using PSCAD/EMTDC and its dynamic response to voltage dips is compared to the dip behavior of an existing 2-MW wind turbine. It will be shown that the developed generic model exhibits the same dynamic performance as the actual wind turbine during and directly after a voltage dip recorded at the wind-turbine site, even in case of a severe event where the voltage at the connection point drops to 0% during the voltage dip.

wind turbine

measurements

fault ride through

voltage dip

modeling

Doubly fed induction generator (DFIG)

Författare

Massimo Bongiorno

Chalmers, Energi och miljö, Elkraftteknik

Torbjörn Thiringer

Chalmers, Energi och miljö, Elkraftteknik

IEEE Transactions on Energy Conversion

0885-8969 (ISSN) 15580059 (eISSN)

Vol. 28 1 76-85 6412788

Ämneskategorier

Energiteknik

DOI

10.1109/tec.2012.2222885

Mer information

Senast uppdaterat

2022-04-05