An Experimental Study to Understand the Effect of Cooling Media at Metal Cutting
Artikel i vetenskaplig tidskrift, 2007

Dry and Semi-Dry machining has gained interest in the last years because of the new environmental legislations and the possibility to decrease the machining cost. However, the role of cutting media such as emulsion, compressed air and Minimum Quantity Lubrication (MQL) on the chip formation has not been understood yet. The mechanical and thermodynamical conditions in the cutting zone affects the properties of work piece material under cutting and these conditions change with the application of cutting media. In this work a medium alloyed forged steel was machined with assistance of emulsion, MQL and only compressed air and the results are compared to dry machining in terms of chip colour, micro structure, white-etching band and contact area between chip and the insert rake face. It was observed that white-etching band, which is believed to be ferrite, forms both on the chip upper free side and chip back side for all conditions. In emulsion cutting, this band has finest grains and with dry cutting it has largest grains proving a slower cooling with dry cutting. Not a big difference was observed on white-etching band when MQL, compressed air and dry machining are compared. However, it was observed that cooling ability of MQL and compressed air has affected the contact area when the media was applied on rake face.

compressed air

White-etching band

MQL

chip micro structure

emulsion

dry

Författare

Bulent Tasdelen

Chalmers, Material- och tillverkningsteknik, Tillverkningsteknik

Varun Nayyar

Chalmers, Material- och tillverkningsteknik, Tillverkningsteknik

Jacek K Kaminski

Chalmers, Material- och tillverkningsteknik, Tillverkningsteknik

Uta Klement

Chalmers, Material- och tillverkningsteknik, Tillverkningsteknik

Lars Nyborg

Chalmers, Material- och tillverkningsteknik

Peter Sotkovszki

Chalmers, Material- och tillverkningsteknik

Maunsrcipt Elsevier- CIRC

Ämneskategorier

Maskinteknik

Bearbetnings-, yt- och fogningsteknik

Mer information

Senast uppdaterat

2018-12-13